U bent hier


Opgelet! Dit event heeft al plaatsgehad.

Development of robust, on-line, vibration-based damage detection techniques

vrijdag, 5 oktober, 2007 - 16:00
Campus: Brussels Humanities, Sciences & Engineering campus
Kristof Harri

A lot of failures in mechanical components are caused by fatigue. It’s
very important to detect damage as early as possible in order to
prevent a possible catastrophic failure. The purpose of this research is
to develop robust on-line damage detection techniques that can detect
and localize the damage in an early stage on a slat track that is fatigue
tested on a test rig.

When aiming at the development of on-line damage detection
techniques, several criteria like the sensitivity, the robustness, the
applicability and the security, should be kept in mind. A study of
through the whole frequency domain (from several Hz to several MHz)
was performed in order to develop a robust and sensitive on-line
damage detection technique.

In the low frequency domain (0-10 kHz) technique based on modal
analysis were used. The basic principle of damage detection by modal
techniques is very simple: the modal parameters of a mechanical
structure depend on the physical parameters of that structure.
Damage will change the physical properties of the structure, which will
cause detectable changes in the modal parameters (eigenfrequency,
mode shapes and damping). Also the influence of the temperature on
the change of the modal parameters has been studied. From the
results, it can be concluded that these techniques suffer (and will
always suffer) from changing boundary and environmental conditions.

In the high frequency domain (1-10 MHz) the reflection and the
transmission of surface (Rayleigh) acoustic waves is used for damage
detection since in most cases the damage evolves from the surface.
The transmission and the reflection of these kind of waves is
influenced by the opening and closing of the crack. This variability will
be used to detect the damage. Also the use of multisines is introduced
to optimize the damage detection capabilities of the Rayleigh waves.
An extension of the developed high frequency technique is made to
plate-like structures. It was found that the high frequency techniques
are very sensitive and robust. Nevertheless, it has to be noticed that
these methods are local methods.

Finally a study in the mid frequency domain (10 kHz - 1 MHz) was
made to cope with the drawbacks of the low and high frequency